Chrome Effect

High quality lacquer with shiny metal chrome effect - called "mirror effect", achieved because of metallic dust „leafing extra”. Recommended for smooth surfaces made of metal, wood, aluminium, glass, ceramics, stone, concrete and some plastics.
Especially practical for works of art and decoration. At florists can be used for fresh and artificial flowers. Chrome effect line has one of the best reputations among competitive products on the market.
 

Notice:

Do not use clear coat on the top. Do not use primers previously.
Weak resistance to abrasion.  Decorative product. 
Best result when applied at 10-25°C.

High gloss – “mirror effect”
Very good covering
Short drying time: 5-10 min
Touch dry: 20-30 min; Hardened: 18-24 h
Efficiency 1,5-2 m² ; 150ml : 0,8 m² depending on colour and type of surface by one application
Limited water resistance – technological reasons
3 colours offer: gold, silver and trendy copper!
Mirror effect depends on painted surface!
For indoor and outdoor use
Capacity to choose: 400 ml or 150 ml
 

Usage:

Before applying read carefully instructions on the container and use according to the manufacturer’s recommendations.
 

Recommended substrate conditions:

Don’t use any priming paint.
Preparing the substrate is very important action influencing the quality and life of varnish coating. Fundamental principle, which relate to all surfaces prepared to painting is to grind, degrease and dry out. After drying the primed surface should be grinded with fine-grained sandpaper (e.g. P600).
 

How to use:

Don’t use any priming paint previously. Do not cover already painted surface by any other paint. Apply product at temperature about 10-25°C (optimum temperature for good varnish drying). Drying time depends also on air humidity and product density. Painting should be made in well ventilated room. Prior to commencing painting, shake the container for about one minute, which will help mix the varnish by the ball found inside. Perform the test spray. Apply the varnish with few thin layers rather than one thick layer, from the distance of 25-30 centimeters. Following applying each layer, wait a few minutes. Following the completion, clean the nozzle. Put the container upside down, pressing the nozzle for the period of three seconds.