Brake Caliper Paint

High quality paint for brake calipers and drums, which gives them special sporty appearance. Very popular for optical tuning of cars and motorbikes. Brake caliper line has one of the best reputations among competitive products on the market.
 

Notice:

Best result when applied at 10-25°C

Petrol resistance
Resistant to abrasion and weather conditions
Heat resistance up 150°C
Protects against corrosion
High gloss
Short drying time: 10-15 min
Touch dry: 30-40 min; Hardened: 24 h
Efficiency 1,5-2 m² depending on colour and type of surface by one application
5 most common colours in RAL system
For indoor and outdoor use
Capacity 400 ml
 

Usage:

Before applying read carefully instructions on the container and use according to the manufacturer’s recommendations.
 

Recommended substrate conditions:

Preparing the substrate is very important action influencing the quality and life of varnish coating. Fundamental principle, which relate to all surfaces prepared to painting is to grind, degrease and dry out. After drying the primed surface should be grinded with fine-grained sandpaper (e.g. P600).
 

How to use :

Apply product at temperature about 10-25°C (optimum temperature for good varnish drying). Drying time depends also on air humidity and product density. Painting should be made in well ventilated room. Prior to commencing painting, shake the container for about one minute, which will help mix the varnish by the ball found inside. Perform the test spray. Apply the varnish with few thin layers rather than one thick layer, from the distance of 25-30 centimeters. Following applying each layer, wait a few minutes. Following the completion, clean the nozzle. Put the container upside down, pressing the nozzle for the period of three seconds.